Livarno 3940/052L User Manual download pdf (Page 8)

8 GB

Preparation / Before installation / Installation

- Pencil / marking tool

- Voltage tester

- Screwdriver

- Electric drill

- Drill

- Edge cutter

- Ladder

Before installation

Important: The electrical connection must be

carried out by a qualiﬁed electrician or someone

trained to perform electrical installations. This person

must be familiar with the features of the light and

the connection requirements.

Familiarise yourself with all instructions and

diagrams in this manual as well as with the

light before installation.

Before installation, ensure that the cable that

the light is to be attached to is not live. Remove

its fuse or switch oﬀ the automatic cutout in the

fuse box (0 position).

Use the voltage tester to check that there is no

voltage.

Installation

Fitting the light

Remove the screws

2

visible on the side of the

terminal housing

6

and take the installation

frame

1

on the back oﬀ (see diagram).

Mark the boreholes using the slotted holes pro-

vided for the screws in the installation frame

1

.

Now drill the screw holes (approx. 6 mm, depth

approx. 40 mm). Ensure that the feed cable is

not damaged.

Insert the dowels into the drilled holes. Fasten

the mounting bracket

1

in place with the

supplied screws.

Connect the light’s connection cable to the

mains connection cable

3

using the insulating

screw joint

4

(see diagram).

Ensure that the cables have been connected in

line with the correct colour coding.

Now connect the earthed conductor (green-

yellow) to the earth terminal labelled in the

terminal housing

6

(see diagram).

Screw the light onto the installation frame

1

using the screws

2

.

Bend the ﬂexible arm

7

to achieve the desired

direction.

Mark the ﬁxing holes for the ceiling brackets

11

.

Note that the drilled holes are always between

two spots

8

(see diagram). This achieves a

more secure fastening.

Drill the ﬁxing holes (approx. 6 mm, depth

approx. 40 mm) for the ceiling brackets

11

.

Insert the dowels into the drilled holes.

Fasten the ceiling brackets

11

in place with

the supplied screws.

Screw the ceiling bracket clips

10

into the

ceiling brackets

11

.

Clamp the ﬂexible arms

7

into the ceiling

bracket clips

10

.

Place the lamp glass

13

carefully over the

ﬁtting

12

and fasten it in place by tightening the

threaded ring

14

using the supplied tool

15

.

Use a clean, ﬂuﬀ-free cloth when you are

replacing a bulb

16

.

Rotate the bulb

16

carefully clockwise into

the ﬁtting.

Check that the bulb is correctly seated.

Your light is now ready for operation.

Directing the light

Never change the direction of the light while it

is switched on.

Allow the light to cool completely.

Turn the individual spots

8

at their bases in

the desired direction. The spots

8

can be

turned through approx. 270°.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 56 57

Comments to this Manuals

No comments