Livarno 103745-14-01-BS/103745-14-02-BS User Manual download pdf (Page 6)

6 GB

Note: Charge the LED work lamp at least once a month, if it is to remain

unused for an extended period of time.

Note: If the LED work lamp has not been charged for an extended period of time

(approx. 2 months), you could ﬁnd that the integral rechargeable batteries have

entered a dormant state. Charge and discharge the LED work lamp a number of

times in succession to reactivate the integral rechargeable batteries.

Before charging, switch the torch

oﬀ (press ON / OFF switch

Plug the male connector of the mains adapter

or of the car adapter

into

the female connector

Note: When charging from a cigarette lighter socket, the adapter must al-

ways be fully inserted into the cigarette lighter socket of the vehicle. Otherwise

there is the danger of ﬁre through overheating.

Insert the mains adapter into a mains socket or insert the car adapter into the

cigarette lighter socket in your vehicle.

Note: The product is ﬁtted with an overcharge protection circuit. Despite this,

you should disconnect the LED inspection lamp from the power supply after the

charging process is complete.

Note: During charging, the charge indicator LED

lights up red. When

charging is complete, the charge indicator LED lights up green. When the

charge indicator LED is green, pull the mains adapter out of the socket or the

car adapter from the cigarette lighter socket. Disconnect the adapter from the

LED inspection light to prevent the batteries from discharging.

Use

CAUTION – RISK OF ACCIDENT! If at all possible, do not use the LED

work lamp in a moving vehicle. If the LED work lamp is used in a vehicle, it must not

be allowed to endanger the safety of the driver or passengers. Always store and

secure the LED work lamp in such a way that there is no risk of injury from or dam-

age to the product, even during full braking.

Note: The LED inspection light

features a magnetic foot

. Ensure the metallic

surface is suﬃciently magnetisable to carry the weight of the light, before you use

the magnetic foot.

Using the LED inspection light without

a power connection

Fully charge the LED inspection light

as described in the section “Charging

the LED work lamp“.

Press the ON / OFF switch

to switch the torch

on or oﬀ.

To switch on the LED inspection light, pull it carefully out of the lamp body,

using the handle

To switch oﬀ the LED inspection light, push the inspection light and the lamp

body back together again, using the handle (see Fig.A).

Troubleshooting

Fault Possible causes and cures

No functions - Mains adapter

or car adapter

is not fully

inserted.

Indicator LED

does not illuminate

When connected to a cigarette lighter socket:

- Is the cigarette lighter socket supplied

with power?

Some

cigarette lighter sockets only supply power with

the ignition switched on.

- Check the fuse in the vehicle.

Charging takes a very

long time

When connected to a cigarette lighter socket:

- Vehicle battery too weak?

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

Comments to this Manuals

No comments

Livarno 103745-14-01-BS/103745-14-02-BS User Manual Page 6

Comments to this Manuals

Related products and manuals for Lighting Livarno 103745-14-01-BS/103745-14-02-BS