Livarno 3940-052L User Manual download pdf (Page 6)

7 GB

Safety / Preparation

due to improper handling or failure to comply with

the safety instructions!

Avoid life-threatening danger

due to electric shock

Ensure that a qualiﬁed electrician or a person

trained to carry out electrical installations per-

forms the electrical installation.

Always check the luminaire, the power supply,

and the mains cable for damage before plug-

ging it in. Never use the luminaire if it shows

any signs of damage.

CAUTION! A damaged mains cable means

life-threatening danger due to electric shock. In

the event of damage, repairs or other problems

with the luminaire, contact the service centre or

a qualiﬁed electrician.

Before installation, remove the fuse or switch

oﬀ the circuit breaker (0 setting) in the fuse box.

Before mounting, ensure that the available mains

voltage corresponds to the operating voltage

required for the luminaire (230–240 V∼).

Strictly avoid the luminaire from coming into

contact with water or other liquids.

Never open a component of the electrical equip-

ment or insert anything into a component of the

electrical equipment. Such interventions pose

life-threatening danger due to electric shock.

Do not install the luminaire on a wet or conduc-

tive substrate!

Avoid fire hazards and

injury hazards

DANGER OF INJURY! Check every bulb

and lamp lens for damage immediately upon

unpacking.

Do not mount the luminaire with defective bulbs

and / or lamp lenses. In this case contact the

service centre for replacement.

DANGER OF BURN INJURIES

Ensure that the luminaire has been

switched oﬀ and has cooled before

touching it, to avoid burn injuries. Bulbs deve-

lop a lot of heat in the area of the lamp holder.

Allow the luminaire to cool completely.

Replace faulty bulbs with new bulbs immedia-

tely. Before replacing the bulb, always remove

the fuse or switch oﬀ the circuit breaker, ﬁrst.

0.5 m

FIRE HAZARD! Mount the lumi-

naire so that it is at least 0.5 m away

from the materials to be illuminated.

Fire can result from excessive heat development.

Do not leave the luminaire or packaging material

unattended. Plastic ﬁlm or bags, plastic parts etc.

can become dangerous playthings for children.

Working safely

Only use 220–240 V∼ energy-saving bulbs with

an E14 ﬁtting and a maximum power output of

9 watt.

Mount the luminaire so that it is protected from

moisture and dirt.

Make careful preparations for mounting and take

suﬃcient time. Clearly lay out all components

and any additional tools or materials that may

be required so that they are readily to hand.

Constant attentiveness is required! Always pay

attention to what you are doing and act with

common sense. Do not, under any circumstances,

install the luminaire if you are having diﬃculty

concentrating or do not feel well.

Preparation

Required tools and material

The tools and materials cited are not included in the

scope of delivery. This information and these values

are non-binding and are provided for purposes of

orientation. The condition of the material is determi-

ned by the individual local conditions.

- Pencil / marking tool

- Voltage tester

- Screwdriver

- Electric drill

- Bit (ø approx. 0.6 cm)

- Side cutting pliers

- Ladder

Introduction / Safety

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Livarno 3940-052L User Manual Page 6

Comments to this Manuals

Related products and manuals for Lighting Livarno 3940-052L