Livarno 3940-052L User Manual download pdf (Page 7)

8 GB

Start-up / Maintenance and cleaning / DisposalPrior to installation / Mounting / Start-up

Prior to installation

Important: The electrical connection must be es-

tablished by a qualiﬁed electrician or a person trai-

ned to perform electrical installations. This person

must be familiar with the characteristics of the lumi-

naire and connection regulations.

Familiarise yourself with all instructions and

diagrams in this manual, as well as with the lu-

minaire before installation.

Before installation, ensure that the cable that the

luminaire will be attached to is de-energised. To

do this, remove the fuse or switch oﬀ the circuit

breaker in the fuse box (0 position).

Use the voltage tester to verify de-energised status.

Mounting

Mounting the luminaire

Remove the visible screws

on the side of the

connection housing

and take oﬀ the moun-

ting bracket

on the rear (see Fig.).

Use the slotted holes intended for the mounting

bracket

to mark the bores.

Drill the fastening bores (approx. 6 mm, depth

approx. 40 mm). Ensure that you do not damage

the supply line.

Introduce the dowels into the bores. Fasten the

mounting bracket

with the provided screws

(large screw head).

Connect the supply cable via lustre terminal

Also ensure that the coloured lines are connec-

ted together.

Connect the protective conductor (green-yellow)

to the earth terminal marked in the connection

housing

(see Fig.).

Use the screws

to fasten the luminaire to the

mounting bracket

Bend the lamp arm

in the desired direction.

Mark the fastening bores for the ceiling brackets

. Ensure that the bores are always between

two spots

(see Fig.). This ensures a more

secure hold.

Drill the fastening bores (approx. 6 mm, depth

approx. 40 mm) for the ceiling holders

Introduce the dowels into the bores. Use the

provided screws to fasten the ceiling holders

(small screw head).

Screw the ceiling bracket clips

into the ceiling

brackets

Clamp the lamp arm

into the ceiling bracket

clips

Place the lamp lens

carefully over the bulb

socket

and fasten it in place by tightening the

threaded ring

using the supplied tool

Use a clean, lint-free cloth to insert a bulb

Carefully turn the bulb

clockwise into the

bulb socket.

Ensure that it is properly seated.

Your luminaire is now ready for operation.

Aligning the luminaire

Only change the alignment of the luminaire

when it is switched oﬀ.

Allow the luminaire to cool completely.

Turn the individual spots

on the base in the

desired direction. The spots

can be turned

approx. 270°, and they can also tilt.

Start-up

Inserting / replacing batteries

Loosen the screw on the battery compartment of

the remote control unit

(rear) by unscrewing

it with a crosshead screwdriver in the

direction.

Remove the spent battery, if necessary.

Insert a new battery into the battery compart

ment.

Only use type A23, 12 V

batteries.

Note: Ensure the correct polarity. This is shown

in the battery compartment.

Close the battery compartment of the remote

control unit

(rear) by screwing in the screw

with a Phillips screwdriver in the

direction.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments

Livarno 3940-052L User Manual Page 7

Comments to this Manuals

Related products and manuals for Lighting Livarno 3940-052L